When your garage door springs break, it can be a serious problem. Not only could you be in danger, but if you leave your garage door unrepaired for too long, you run the risk of break-ins or vandalism.
Trying to fix a broken garage door spring on your own is risky, so you should call a professional to repair it as soon as possible. But what if you have no choice? What do you do when there’s nobody else around who can help? It’s not a decision to make lightly, but with the right safety equipment, garage door springs are easily fixable by even the most inexperienced DIYer.
What Is a Garage Door Spring?
The purpose of a garage door spring is fairly simple: It helps lift the door up and down without requiring extra manpower. But just how do they work?
Garage Door Springs Explained
Spring-loaded doors are used in garages to keep them looking sleek and modern. They’re also very strong. In fact, many of them require two separate springs to carry their weight. One spring will push the door upwards while another pulls it downwards. The metal coils that make up each spring need to be tightened regularly for optimal use and security purposes.
What Do You Need to Do to Fix Broken Springs?
Garage door springs are very dangerous. If you are not experienced, please do not attempt to replace your garage door spring repair Portsmouth VA. Having said that, if you decide to replace the spring yourself, perform the following steps:
- Park the car in a safe location away from the garage door.
- Place a wooden block on the button of the opener. This will prevent the garage door from closing unexpectedly and injuring you or someone else.
- Close the garage door manually, if possible, and pull it down until it stops.
- Locate the broken spring using a flashlight and angle grinder with cut-off wheel attachment or hacksaw blade. Make sure you have adequate ventilation and have put on a welding helmet and/or goggles before entering this area while working on your garage door opener.
- Cut through the eye nuts or threaded rod holding either end of the broken spring by using an angle grinder or hacksaw blade with cut-off wheel attachment, taking care to position your body so as not to be struck by flying debris while cutting through these objects at such close range. Once both eye nuts or threaded rods are severed, remove them from their anchorages on each side of the track.